Ski Boat Forum
Buy and Sell => Boat Parts Wanted => Topic started by: Arne3680 on August 18, 2013, 07:28:18 AM
-
Does anyone has the same "plug in" navigation light connection?
And are the navigation lights available?
(http://imageshack.us/a/img716/9196/4t51.jpg)
-
That was either a std. Attwood or Perko light, round hole with orienting slot, 2 round pins for elect. connection, sound right, if so several were interchangeable, I've even seen these for sale at Wally world.
-
Thanks Ron!
I'm allready searching for one!
I think it's an Attwood if I look at the pictures.
Or is there no difference between the two?
-
Many in this age were interchangeable
-
Carefully measure the length and width, some later models have been shorter overall the 2 screw holes at one end will line up but the other side may not cover the original 3rd hole
Dan T
-
I have only 2 pins.
-
yes 2 pins / for 2 wires a switched hot and a ground
the actual fitting has 3 screw holes to mount the fitting to the deck - and the newest attwood fitting is about 3/8" (10cm?)
shorter than the old one
the 2 screw holes in the front will line up correctly, you will have to drill a new 3rd hole @ the rear of the fitting - unfortunately the new attwood fitting will not completely cover the original 3rd hole
Dan T
-
Is it not possible to buy just the pole light?
Or will this not fot in the original fitting?
-
Yes, you should be able to buy the pole/light. I did that several yaers ago. Perko makes afew of them that should plug right in.